15
6) SHARPENING AND LUBRICATION
6.1. SHARPENING
THIS A VERY IMPORTANT OPERATION TO CARRY OUT EVERY TIME THE CUTTING IS NOT
CLEAN, OR WHEN THE BLADE DRAGS THE SLICE.
THE USE AND THE TYPE OF PRODUCTS THAT HAVE BEEN SLICED DETERMINE THE
PERIODICITY OF THIS OPERATION.
BEFORE SHARPENING THE BLADE, CLEAN THE MACHINE AND DEGREASE THE BLADE
ACCURATELY.
1. INSERT THE POWER SOCKET
2. LOOSEN KNOB "A" (see fig. 14)
3. LIFT THE SHARPENER AND ROTATE IT 180° SO THAT THE BLADE IS BETWEEN THE TWO
GRINDERS. (see fig. 14)
4. SCREW THE KNOB “A”.
5. PRESS BUTTON “B” FOR AT LEAST 5-10 SECONDS TO CARRY OUT THE GRINDING. (see fig. 15)
6. PRESS THE “C” BUTTON FOR A FEW SECONDS TO REMOVE ANY BAVA. (see fig. 15)
7. TURN OFF THE MACHINE AND RETURN THE SHARPENER TO THE INITIAL POSITION.
WARNING
:USE BUTTON "B" TO SHARPEN, AND BUTTON "A" TO DEBURR THE
CUTTING EDGE.
DURING THE SHARPENING PROCESS, KEEP TO THE ORIGINAL DRAWING OF THE
BLADE BEVEL. REPLACE THE BLADE WHEN THE CLEARANCE BETWEEN THE RING
AND BLADE EXCEEDS 6 MMS.
6.2. LUBRICATION
PERIODICALLY LUBRICATE THE SLIDING ELEMENTS WITH WHITE VASELINE OIL.
FOR NOT DAMAGING THE SLICER, NEVER USE SEED OIL OR OLIVE-OIL. LUBRICATE ALL
ELEMENTS USING THE OILERS AS SHOWN IN FIGURE. (see fig. 16-17)
6.3. MACHINE IDLE FOR A LONG TIME
SHOULD THE MACHINE BE IDLE FOR A LONG TIME, DISCONNECT THE WALL MAIN SWITCH
AND CLEAN THE MACHINE AND ITS ACCESSORIES ACCURATELY.
USE WHITE VASELINE OIL (OR SIMILAR PRODUCTS) TO PROTECT ALL THE MACHINE
ELEMENTS. WE ADVISE COVERING THE MACHINE WITH A NYLON (OR SIMILAR) CLOTH.
Содержание GPR 350 MN
