CellarPro AH12S Series, Руководство пользователя

Страница: 33 / 33

V12.21
33
**REQUIRED** TO ACTIVATE THE WARRANTY
INSTALLERS MUST FILL OUT THIS SHEET AND FAX TO
707.794.8005 OR SCAN & EMAIL TO INFO@CELLARPRO.COM
CellarPro Split Systems must be installed by an experienced professional in adherence with industry practices and
as described in the manual. If you need technical assistance during the installation, call 877.726.8496 x2.
Tech Name: ____________________ Tech Phone: ______________ Date of Measurement: _____________
System Information Piping Information
MM/DD/YY
Customer Name
R-134a System Charge
(lb)
Condensing Unit Model # Line-set Length (ft)
Condensing Unit Serial # Liquid line diameter (OD)
Evaporator Model #
Suction line diameter
(OD)
Evaporator Serial #
Trap installed in drain
line, charged with water,
and tested for drainage
(Y/N)
Operation Start Date
Initial Refrigerant Charge Through (Check One) ____ Suction Access Valve ___ Liquid Access Valve
Operational Data: Take the following measurements during a normal refrigeration cycle, once the cellar has pulled down
to the set-point temperature. Make sure the compressor is running when recording the data
.
Evaporator Range
Air temp. at Evap coil (°F) Inlet Outlet TD 8-10°F TD
Evaporator power supply Volts Amps
187-253V
nameplate amps
Condensing Unit
Air temp at Condenser coil (°F) Inlet Outlet TD 20-30°F TD
Condenser fan status __ On __ Off
Suction readings access valve PSIG °F SH
25-35 PSIG
20°F Min. Superheat
Liquid readings at access valve PSIG °F SC
105-180 PSIG
8-12°F Subcooling
Emerson Controller Parameters Cin Cou EdF
Condensing unit power supply Volts Amps
187-253V
nameplate amps
Please provide the email address to contact with the
warranty activation: