Celestica A2210, Руководство пользователя, Страница: 39 / 76

U S E R ’ S M A N U A L
Figure 16 - Removing the Power Supply
4. Remove the plug in the rear of the power supply and disconnect it from
the Front Access Panel Board by pulling it toward the rear of the
chassis. Separate the power supply from the front access panel board by
pulling the power supply toward the rear of the chassis.
5.
Remove the 11 screws that holds the front access panel board to the
chassis to free the board.
To replace the board, complete all of the above steps in the reverse order with a new
front access panel board.
6.5 Replacing the PCI Riser Card
The A2210 uses one of two PCI riser cards – one that supports two PCI-X cards, or
one that only supports one. It is preferable to use the single-card riser if only one
PCI-X card is used in a system. To replace the PCI riser card, follow these steps:
1.
Remove the PCI-X cage and all PCI-X cards as described in the section
entitled “Replacing the PCI-X Cards.”
2. Unscrew the riser from the PCI-X cage as shown in Figure 17.
6-5