pg. 12 Copyright © 2012 Celeno Communications™ - All Rights Reserved | www.celeno.com
Unit Mode (AP/STA) Setting
To set/modify the VXT1836 device operating mode:
1.
Make sure the unit is UNPLUGGED from the 12V A/C adapter – check that all LEDs
are off.
2.
Change the AP/STA Mode switch at the back of the unit to the desired mode:
Note:
Only a single VXT1836 unit should be set as an AP in the network, the remaining
units should be set as STAs.
Powering Up your Devices
To power up the VXT1836 device:
3.
Plug in the 12V A/C adapter and connect it to the VXT1836 device.
Use the recommended AC/DC power adaptor which was supplied in the kit.
Using a power supply with a different voltage rating then the one included with the
VXT1836 device will cause damage and void the warranty for this product.
Note:
There is no On/Off switch. Once you connect the power adapter, the VXT1836
device powers up.
4.
Wait several seconds while the VXT1836 device performs a reset.
Switch on top position
for “AP” (Access Point) mode
Switch on bottom position
for “STA” (Station) mode
