Fig 18. Selection serial port profile page
5.2.2.1.1. REALPORT (VIRTUAL PORT )
Choosing
RealPort
(Virtual Port, Fig. 18) is configured the serial port of ADA-14040 server, for communication with virtual port COM of
computer. Press [
Apply
] for save. After installing drivers of virtual port COM in operating system, data sending by application to this
port are transferred through WLAN/WAN to ADA-14040 server and are present on his serial port. The drivers
RealPort
installation is
presented in chapter 6. Normally
RealPort
service allows for one connection through WLAN/WAN, between computer and server port.
Connection from other computers to the server will be not taken, what will cause the error message.
5.2.2.1.2. TCP SOCKETS
Choosing
TCP Sockets
is configured the serial port of ADA-14040 server, for communication with PC by the use of TCP socked.
Data sending by application to TCP socked are transferred through network. Press [
Apply
] for save.
5.2.2.1.2.1. TCP SERVER AND CLIENT
After saving the TCP Sockets profile, will open section
TCP Server Settings
(picture below), includes configuration of:
–
port for Telnet service; standard 2001,
–
port for serial port service; standard 2101 (through this port are transferred data to serial port of server),
–
port for security access to serial port service; standard 2601 (through this port are transferred data to serial port of server),
and possibility of selection
Enable TCP Keep Alive
– connection will be kept, even if the data is not transmitted over the network.
18
ADA-14040
