Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
10
5.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network interface
D.
Use caution when installing or modifying telephone lines.
E.
DO NOT APPLY A/C POWER WHILE INSTALLING
TELEPHONE.
5.01 Recommended tools and test equipment:
CEECO Security Tool, 301-064
Flat blade or Phillips head screw driver
Wire Strippers
5.02 Using a 301-064 security tool (sold separately) loosen and remove the four (4)
security screws. Separate the faceplate assembly from the weatherproof housing
by pulling the faceplate forward.
5.03 Run the inside station wire into the enclosure and terminate on the RJ11C
modular jack inside, as depicted on the following page. The CEECO-provided
jack must be used as it contains required over-voltage protection. Mount the
housing in the intended location using the four mounting holes provided. There
is a pole-mounting bracket available, which is sold separately.
5.04 The use of a gas tube station protector is recommended. The station ground
should not exceed 50 ohms.
