Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
8
PROGRAMMING CONTINUED…
•
Be sure to record your selections below for future reference:
#00
0 __ __ 0 0 __ 0 __ 0 __
1 2 3 4 5 6 7 8 9 10
EXAMPLE:
Enter #00 0160000005
Phone will be set as follows:
DIGIT 1 -- ALWAYS 0
DIGIT 2 -- ALWAYS 1
DIGIT 3 -- 6 MINUTE TIME OUT FOR EMERGENCY CALLS
DIGIT 4 -- ALWAYS 0
DIGIT 5 -- ALWAYS 0
DIGIT 6 -- SECOND NUMBER DIAL DEACTIVATED
DIGIT 7 -- ALWAYS 0
DIGIT 8 -- DO NOT DIAL PBX NUMBER STORED IN LOCATION #18
DIGIT 9 -- ALWAYS 0
DIGIT 10 -- 250ms WINK
3.09
Press the “CALL" button
to hang up the phone and return the
mini-jumpers
to
the
"OFF"
position, as depicted on the last page of this manual.
3.10
Voice Announcement
•
To record the voice announcement
, press the RED Button
, and the phone
will dial the preprogrammed number in location #19. It may be easier to use
another working number to do this, other than 911. In such a case, move the
jumpers to enter the programming mode, press the button, enter only #19,
followed by the working number and then hang up and move the jumpers
back. Press the button and proceed. When done with the last item in this
section, follow this process again to restore the emergency/911 number.
•
Ask the called party to put their telephone on
HOLD
or remain quiet while
you prepare to record the message.
•
Refer to the diagram on page 23 to locate the
Voice Record Switch
on the
printed circuit board.
Toggle
the record
switch
to the
ON
position. The
phone's LED will turn red.