CEECO SSP-511-FD-ADA-AA-RP, Руководство по обслуживанию, Страница: 15 / 24

ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
15
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1 Using a 301-064 security tool ( sold separately ) to remove the four
locking screws.
6.2 The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3 Separate the telephone assembly from its housing or mounting.
6.4 Run the inside station wire through the housing or mounting and terminate
on to the RJ11C modular jack inside, as depicted in the diagram on the
following page. The CEECO-provided jack must be used, as it contains
required over-voltage protection.
6.5 The use of a gas tube or carbon station protector is recommended. The
station ground should not exceed 50 ohms.
6.6 Plug the modular line cord from the PC board into the RJ11C terminal
block.
6.7 Dress the line cord away from the locking screws and seat the telephone
assembly into the housing or mounting.
6.8 Secure the telephone assembly by inserting and tightening the security
screws.
*****WARNING*****
A. Never install telephone wiring during a lightning
storm.
B.
Never install telephone jacks in wet locations unless
the jack is specifically designed for wet locations.
C. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the
network interface.
D.
Use caution when installing or modifying telephone
lines.