ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
3.0
PROGRAMMING
3.1
Separate the telephone assembly from its mounting or housing by
loosening the four security screws on the stainless steel panel with a
security tool (sold separately) and remove them.
3.2
Connect the telephone
to a working telephone line or DTMF test set.
3.3
Locate the two plastic
mini-jumpers
on the edge of the PC board and
place them in the
"ON"
position, as depicted on the last page of this
manual.
3.4
Press
the
LEFT
black call button
on the front of the panel to begin
programming. You should receive dial tone.
3.5
Each programming location is accessed by dialing the "#" sign and a two
digit code. The valid program locations are #00, #01, and #19. The
previous contents of the location are automatically erased when the
location code is dialed.
3.6
To begin,
enter #97
on the keypad to clear all user-programmable
memory.
NOTE:
Once the # key has been entered, you may hear a fast busy tone,
an operator recording, or other Central Office signals. Please disregard
these sounds and continue programming, as they will have no effect on the
programming.
3.7
Location "00" is the telephone options program location. By entering 0 or
1 into each of the 5 digits found under location #00 on the next page, the
phone is customized to each particular installation. So after dialing #97,
enter #00 followed
by
your selections for the
five digits
. For example,
enter #97#0000101. This entry will set the phone for no incoming calls,
wide dial tone-detection window, time-out disconnect enabled, with a 3
minute time-out. Notice that the dialing is done in a continuous sequence
with no pauses or steps in between.
