ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
3.0 PROGRAMMING
3.1 First
read
through the programming section and then do the actual
programming as you read along again. Programming is accomplished by
way of the DTMF keypad. The programming can be accomplished in one
continuous sequence without having to stop or perform any measures
between programming sections. It is important to be slow and deliberate
when pressing the keys during programming. A missed or partial tone
will result in improper programming.
Connect the telephone
to a working
telephone line or a DTMF test set.
3.2
Locate the two plastic
mini-jumpers
on the edge of the printed circuit
board and move them to the
“ON”
position, as depicted on the last page of
this manual.
3.3 Lift
the
handset
and wait for dial tone before beginning programming.
3.4
The normally configured keypad is utilized to perform all of the
programming of the telephone (Please refer to the diagram on the page 7).
Utilizing this keypad,
enter # 9 7.
This will
clear all memory
locations.
3.5
Enter # 0 0
, which accesses the telephone options memory location.
There are six (6) selections to be made in this location. By entering a
selection into each of the six programming digit locations, the phone is
customized for the particular installation. You must make an entry for
each of the six digit locations. The six digit locations and the available
selections are shown on the next page. Compare the example below to the
information on the next page and
then enter the 6 numbers
you choose
.
Example
: Entering #00 followed by 101003 would program the phone to
have no call restrictions, no incoming call allowed, a wide dial tone detect
window, a muted microphone initially, DTMF dialing, and a 5 minute
automatic timed call disconnect.
