Cedes TOF/Start-EA, Инструкция по установке и эксплуатации

Страница: 5 / 12

TOF/Start-EA English
© CEDES | V 1.0 5
Important:
The scale is not printed on the sensor. The
potentiometer can be adjusted linearly from 0.4 m to
2.0 m; see Figure 3 below.
Take a small screw driver and turn the potentiometer
to the required position.
(all dimensions in mm)
Figure 3: Detection field using potentiometer
Table 1: Parameter - detection field
6. Installation
Important:
The TOF/Start-EA must be mounted at a minimum 10°
mounting angle to the ground.
Figure 4: Mounting angle of TOF/Start-EA
7. Input / Output description and
electrical connection
Generally the TOF/Start-EA has one output that is triggered
if the detection field is interrupted. For this purpose, a
push-pull output is used. With the logic selector (gray wire,
Figure 6), the logic of the output signal can be configured
for “HIGH“ on object or “LOW“ on object operation
(Figure 5), according to the controller requirements.
The logic selection is performed during start-up.
Figure 5: Output (PNP/NPN) logic
Figure 6: Connection diagram
8. Start-up
1. Switch on mains and power up.
2. Check if LED lights up.
3. Check the distance setting and the reaction of the
sensor, including the status LED, by placing an object
into the detection area at different heights and widths.
0 ... 1000
Area without cross-traffic
x-axis
y-axis
70°
20°
x = min. 400 ... max. 2000
y = min. 400 ... max. 2000
2 m
1.2 m
0.4 m
0.8 m
1.6 m
2 m
1.2 m
0.4 m
0.8 m
1.6 m
Parameter Value
Operating range
x-axis Min.: 0 ... 400 mm
Max.: 0 ... 2,000 mm
Operating range
y-axis Min.: 0 ... 400 mm
Max.: 0 ... 2,000 mm
Aperture angle 70°
U
SP
0 V
Output
Logic selector connected to GND (0 V)
U
SP
0 V
Output
Logic selector connected to U
SP
Con
tr
oller
U
SP
GND (0 V)
n.c.
Selectable output logic
Output
n.c. = not connected and isolated
n.c.
black
brown
green
blue
white
gray
TOF/Start-EA
10°