WARNINGS AND NOTES
WARNING:
Ensure that the top and bottom port covers are clean and securely seated before exposing the unit
to water. Failure to perform this step could lead to water damage of the unit.
NOTE:
Use only the supplied Micro USB cables for charging the device and transferring data. Some existing USB
cables will not charge the device because the barrel is too large, or the connector is too short.
INSTALLING A SIM CARD
The CT5 only accepts micro SIM cards.
1
Use a screwdriver to loosen and remove the two screws on the rear port cover.
2
Carefully lift and remove the rear port cover and the rubber pad.
3
Use the graphic and the plastic guide in the compartment to orient the SIM card for either the top SIM slot or the
bottom SIM slot, and gently push the SIM card into place.
CAUTION:
Do not force the card in or out of the slot as this may damage the device. If the card does not seat
properly or does not function correctly, check the card orientation and try again.
NOTE:
The compartment provides two SIM card slots in a stacked configuration.
4
Orient and replace the rubber pad so that it rests flat in the recessed area.
5
Orient the rear port cover by aligning the three tabs on the cover with the slots in the case and press it into place.
6
Secure the rear port cover by using a screwdriver to tighten the two screws. The screws should be snug. Do not
over-tighten the screws as this can damage the device.
INSTALLING A MICRO SD CARD
The CT5 only accepts micro SD cards. Do not use other sizes of SD cards.
1
Use a screwdriver, loosen and remove the two screws on the rear port cover.
2
Carefully lift and remove the rear port cover and the rubber pad.
CAUTION:
The micro SD connector and door are fragile. Use care when opening and closing the door.
NOTE:
The micro SD connector is under a small metal, latched door. Arrows printed on the door indicate the
direction to slide the door to open or lock it.
3
Open the micro SD connector door by gently pressing and sliding the door toward the top of the device (refer to the
arrows printed on the metal door). In this position, the door should easily swing open.
4
With the micro SD connector door open, carefully align and place the micro SD on the connector. Check to make
sure the notch on the card aligns with the plastic features on the connector.
