www.usaprocom.com
200028-01A
18
INSTALLATION
PRESSURE TESTING HEATER GAS CONNECTIONS
1. Open equipment shutoff valve (see Figure
16, page 17).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shutoff
valve to control valve (see Figure 17 or
18, page 17). Apply a noncorrosive leak
detection fluid to all joints. Bubbles form-
ing show a leak.
5. Correct all leaks at once.
6. Light heater (see
Lighting Instructions
on
page 21). Check all other internal joints
for leaks.
7. Turn off heater (see
To Turn Off Gas Ap-
pliance
, page 21).
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to high, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
INSTALLING LOGS
Model CRHLD18TB (18" Log Set)
Log #1
Log #2
Rear Log
Bracket
Middle Log Bracket
Front Log
Bracket
Grate
Figure 20 - Installing Logs #1 and #2
Figure 19 - Heater Base Assembly
1. Insert pins on the back of log #1 into slots
in rear log bracket on heater base, and
tighten nuts (see Figure 20).
2. Insert pins on the back of log #2 into slots
in middle log bracket on heater base, and
tighten nuts (see Figure 20).
3. Insert pins on the back of log #3 into slots
in front log bracket on heater base, and
tighten nuts (see Figure 21, page 19).
It is very important to install the
logs exactly as instructed. Do
not modify logs. Use only logs
supplied with heater. Each log
is marked with a number. This
number will help you to identify
the logs when installing. After
installing logs, add decorative
cinders around the grate base,
do not place any decorative
cinders on logs or burner.
