cecotec CONGA WINROBOT 870, Инструкция по эксплуатации

Страница: 9 / 15

ENGLISH
19 CONGA WINROBOT 870
5. Low battery and cleaning (Red 1 and blinking blue 2)
6. Fully charged and cleaning (Blue 1 and blinking blue 2)
1 2
5 4
3
6
Cleaning tips
•
Step I: Use clean and dry cleaning cloths to clean the dust and dirt on the window.
• Step II: Change the cleaning cloths when dirty. Spray a little bit of detergent (1~2 spray) on
the lower wheel and keep the upper wheel dry. Do not wet the cloth too much (if it gets
too wet, the machine cannot move properly). Then, clean the window again.
Operation
•
Step I: Connect the robot to the mains suppy and tie the safety rope. Make sure the battery is
fully charged.
• Step II: Place the microfiber cloth in the cleaning wheels.
• Step III: Turn on the robot and place it on the window.
• Step IV: Choose the cleaning mode with the remote control.
• Step V: When the robot stops cleaning, grab it by the handle, turn off the switch, and remove it
from the window.
3. REMOTE CONTROL
Up Start/Pause
Down Auto Up then Down
Left Auto Left then Down
Right Auto Right then Down
Stop Clean the window twice