cecotec Conga 8090 Ultra, Инструкция по эксплуатации

Страница: 38 / 44

38 | CONGA 8090 ULTRA
ENGELSK
Spot mode
- Select this mode if you want to thoroughly clean a specific point in the
map, making the most of the robot’s maximum power. The robot will
clean a 2x2 m zone in zigzag motion and then will return directly to the
charging base when cleaning is completed. The robot will only clean the
area selected on the map, therefore it will go to the point and return to the
base without vacuuming.
- It can only be activated from the App.
Restricted area mode
- Select this mode and delimit in the map specific areas where you do not
want the robot to clean. You can set more than 1 restricted area at the
same time on the map.
- It can only be activated from the App.
Twice mode
- Use this mode to carry out a deep, thorough cleaning of your home.
- It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot
will carry out 2 full cleaning cycles and then will return directly to the
charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and
backward several times in order to eliminate any rests of dust from the
brush.
6. Cleaning and maintenance
Main brush
- Turn the robot around and press the main brush’s release button to take
the cover out.
- Take the main brush out and clean the compartment.
- Clean the main brush with the provided tools and use water and soap if
necessary.
- Place the main brush in its position and fasten the cover’s clip.
Recommendation
Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 22.
- Main brush cover