cecotec Conga 7090, Инструкция по эксплуатации

Страница: 22 / 34

43 42
7090 7090
ENGLISH ENGLISH
2
. PARTS AND COMPONENTS
Robot:
Fig. 1.
1. Back home mode
2. Power/Automatic cleaning button
3. Network configuration
4. Visual detection sensor
Robot and sensors
Fig. 2.
1. Laser sensor
2. Top cover
3. Back home/Power/Autocleaning mode
4. Infrared receiver sensor
5. Anti-collision sensor
6. Omnidirectional wheel
7. Charging terminals
8. Battery
9. Side brush
10. Bumper
11. Motor cover
12. Main brush: For cleaning all types of surfaces
13. Left side wheel
14. Right side wheel
15. Silicone brush: Special for pet hair
16. Jalisco brush: Specific for hard floors
17. Optical sensor: Specific for preventing the robot from bumping
Wet&Dry tank
Fig. 3.
Water compartment
1. Tank lock
2. Water inlet
3. Water tank
Dust tank
Fig. 4.
1. High-efficiency filter
2. Dust tank
Dust tank
Fig. 5.
1. Dust tank
2. Primary filter
3. High-efficiency filter
4. Dust tank cover
Charging base
Fig. 6.
1. Signal transmission area
2. Charging terminal
3. Charge indicator
4. Cable slot
5. Charging terminal
Mop bracket and cloth
Fig. 7.
1. Mop
2. Mop bracket
3. Velcro
4. Tab
3.
BEFORE USE
Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of
visible damage is observed, contact immediately with our official Technical Support Service.
4
. INSTALLATION
Robot and charging base installation
Fig. 8.
Connect the charging base to a power supply and store the remaining cable. It is important
to store the remaining cable at the bottom of the charging base to avoid it from being
dragged and disconnected.
Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Note: Ensure a space of at least 1 m on both the left and right side of the charging base, and
a space of at least 2 m in front of it.
Fig. 9.