cecotec bolero DRESSCODE DRY 9500 ION, Инструкция по эксплуатации

Страница: 64 / 168

BOLERO DRESSCODE DRY 9500 ION
127 126
ENGLISH ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1.
Upper tray
2.
Control panel
3.
Loading door
4.
Base
5.
Base opening slot
6.
Ventilation grids
7.
Adjustable feet
8.
Base cover
9.
Type plate
10.
Lint filter
11.
Drawer cover
The graphics in this manual are schematic representations and may not exactly match the
product.
Box contents
- Bolero DressCode Dry 9500 Ion dryer
- Drain hose
- Instruction manual
2. BEFORE USE
- This product includes a package designed to protect it during transport. Unpack the
appliance and keep the original packaging and materials in a safe place. It will help
prevent any damage if the product needs to be transported in the future. In case the
original packaging is disposed of, make sure all packaging materials are recycled
accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Technical Support Service of Cecotec
immediately.
3. INSTALLATION
Connection of the water outlet (with optional drain hose)
In appliances with a heat pump unit, water accumulates in the water tank during the
drying process. You must empty the water accumulated in every drying process. Instead of
periodically emptying the water tank, you can also use the water drain hose supplied with the
product to drain the water directly from the exterior.
Drain hose connection
Fig. 2
1.
Remove the end of the hose located in the rear of the dryer. Do not use any tool to remove
the hose.
2.
Place an end of the drain hose, provided with the product, in the hole from which you
removed the hose.
3.
Adjust the other end of the hose directly to the water supply or sink.
ATTENTION: You must place the hose so it cannot move. If the hose slips out during the
water draining, your house could be flooded.
IMPORTANT: The drain hose must have a maximum length of 80 cm.
IMPORTANT: The drain hose between the water supply and the product must not be
twisted, bent or crushed.
Adjusting the feet
For the dryer to operate with as little noise and vibration as possible, it must be stable and
balanced on its feet. Adjust the feet to make sure the product is balanced.
Turn the feet to the right and left until the dryer is level and stable.
IMPORTANT: Never remove the adjustable feet.
Electric connection
ATTENTION: There is a risk of fire and electric shock.
- The current of the dryer is set to 220-240 V and 50 Hz.
- The power cord of the dryer is equipped with a special plug. This plug must be connected
to a grounded outlet protected by a 16 ampere fuse, as indicated on the type label. The
current rating of the power line where the socket is connected must also be 16 amperes.
Seek the advice of a qualified electrician if you do not have such a socket or fuse.
- Cecotec is not responsible for any damage caused by ungrounded use.
IMPORTANT: Operating your machine at low voltage values shortens the lifetime of the
machine and reduces its performance.
- Always use the plug provided with the dryer.
- Do not modify the plug provided with the device if it does not match the power socket.
Installation under a worktop
- Leave at least 3 cm of space between the side and rear panels of the product and above
the product if the appliance is placed under a worktop.
- If assembly/disassembly of the system under a worktop is necessary, this must be
carried out by an authorised service technician.