43
42
ENGLISH
ENGLISH
CONGA ROCKSTAR 500 X-TREME ERGOFLEX
CONGA ROCKSTAR 500 X-TREME ERGOFLEX
It can be assembled with screws (included with the product), or with an adhesive (included
with the product).
When using the adhesive, make sure to use it on a clear flat surface.
Also make sure that the suction base rests on the floor when hang to avoid the wall bracket
from falling.
Fig. 9
Charging
The device can be charged in 2 different ways. It can be charged directly through the handheld
vacuum cleaner or the battery can be removed and charged separately.
It is important to charge it when the battery is low. While charging, the battery indicator will
turn on red, and it will turn green when battery is fully charged again.
Disconnect it from the power adapter when the battery indicator is lit up in green.
Fig. 10
5. CLEANING AND MAINTENANCE
Do not use abrasive scouring pads, powders or cleaners to clean the product.
Use a soft, dampened and clean cloth to clean the product’s outer housing.
Do not let water enter into the vacuum cleaner.
Keep the appliance in a cool, dry place and out of reach from children.
Do not immerse the device in water and do not clean any of its parts in the dishwasher.
Dust tank
To empty the dust tank, first disassemble the handheld vacuum cleaner from the rest of the
unit. Use the tab on the dust tank to open its cover and empty it. If necessary, shake it gently
to remove all the dust.
Fig. 11
To clean it, press the dust tank release button and turn the dust tank anticlockwise to the
unlock position. Remove it. Use water to rinse it. If necessary, clean it with soap to remove all
the dust.
Recommendation: It is suggested to clean the dust tank after each use.
Fig. 12
Filters
It is suggested to clean the filters regularly to ensure maximum efficiency. They can be cleaned
with warm water. Dry them thoroughly before installing them back in the device.
To take filters out:
Open the dust tank following the instructions on the before section.
Turn the metallic filter anticlockwise and remove it.
Fig. 13
Unscrew the plastic cyclone and remove it too.
Pull from the tab located on the top of the handheld vacuum cleaner and remove the high-
efficiency filter.
Wash all of them with warm water.
Allow them to dry completely before installing and using them again.
Fig. 14
Jalisco brush
Recommendation: It is important to clean the brush regularly to avoid hair and other foreign
objects from tangling and to prevent blockages.
Press the brush release button on the bottom part of the suction base and remove the brush.
Wash it with warm water. Do not use detergents or soap.
Make sure it is completely dry before installing it back in the device.
Fig. 15
6. TROUBLESHOOTING
Problem
Possible reason
Solution
The motor does not operate.
No battery.
The vacuuming tube, brush,
battery, suction base or
handheld vacuum cleaner are
not assembled in place.
Charge the vacuum
cleaner.
Check that the
components and the
handheld vacuum cleaner
are assembled correctly.
Suction power level is very
low.
The dust tank is full.
Filters are dirty or blocked.
Air inlet of the vacuuming
tube or suction base are
blocked.
Empty the dust tank.
Clean or replace the filter.
Clean the dirt attached to
the brush.
The operating time after
charging has decreased.
It has not been enough
charged.
Battery is damaged or too old.
Charge the battery
completely.
Replace the battery.
Note: For any further doubt, please contact the official Technical Support Service of Cecotec.
