DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER
DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER STEEL
69
68
ENGLISH
ENGLISH
Water leakage
Bad connection between the
pipes and the water supply
hose or the drain hose.
Check and fasten the water
pipes and hoses correctly.
Clean the hoses ensuring they
are not blocked.
There are detergent remains
in the detergent dispenser.
Detergent is dampened or
agglomerated
Clean and dry the detergent
dispenser.
Dilute the detergent with
some water.
Indicator or display does not
light
The PCB is disconnected, or
the system connector has
connection problems
Check for power supply.
If the problem persists,
contact the official Technical
Support Service of Cecotec.
Abnormal noise
Check if the fixing bolts have
been removed.
Make sure the appliance is
installed on a solid, level
floor.
Level the washing machine
adjusting its feet.
Errors
Error
Cause
Solution
E30
Door is not closed properly
Close the door and restart it.
Check if there is laundry or
dirt stuck.
E10
Water injecting problem while
washing
Check if the water pressure is
too low.
Stretch the water supply
hose.
Check if the inlet valve filter is
blocked. Clean the filters.
E21
Overtime water draining
Check if the drain hose is
blocked.
Remove any type of object
or dirt which may block the
water outlet. Check there are
no blockages in the water
supply and/or drain hoses.
E12
Water overflow
Restart the appliance.
Cleaning the drain pump filter
Warning
Be careful with hot water! Allow any possible water remains to cool down.
-
Unplug the machine from the power socket to avoid electric shock before washing.
-
The drain pump filter can filter the yarns and small objects from the washing.
-
Clean the filter periodically to ensure proper operation of the washing machine.
-
Open the lower cover cap. Fig. 33.
-
Rotate the emergency drain hose 90°C and pull it out, and remove the hose cap. Fig. 34.
-
Empty the water in a suitable container, once it is completely empty, reinstall the drain
hose. Fig. 35.
-
Remove the filter by turning it counterclockwise. Fig. 36.
-
Remove dust, dirt and other substances or objects. Fig. 37.
-
Place the filter again in its original position by turning it in the other sense
-
Open the lower cover cap. Fig. 38.
Warnings
-
Make sure the cap and the emergency drain hose are reinstalled properly, cap plates
should be inserted aligned to the plates gap.
-
Some machines do not have emergency drain hose, so you can skip step 2 and step 3.
-
Rotate the lower cover cap (filter) so water runs directly into a suitable container.
-
When the appliance is in use and depending on the programme selected there can be hot
water in the pump. Do not remove the lower cover during the wash cycle, always wait until
the appliance has finished the cycle and is empty.
-
When replacing the cover, ensure it is securely re-tightened.
6. TROUBLESHOOTING
Problem
Cause
Solution
The washing machine does
not start up
The door is not properly
closed.
It is not connected to a power
outlet
Close the door and restart it.
Check if there are clothes
stuck.
Connect it to a mains socket.
Check that the control and
protection elements of the
electrical installation are
activated.
The door does not open
The safety lock system is
activated
Unplug it and restart the
product.
