POWER ESPRESSO 20 TRADIZIONALE
POWER ESPRESSO 20 TRADIZIONALE
19
ENGLISH
Remove excess coffee from the filter’s edge to ensure easy assembly of the portafilter in
the unit and to ensure good operation.
Note: Pressing coffee down is a very important part of brewing coffee. (Img.2)
Installing the portafilter (Img.3)
Rotate the portafilter to the left to remove it.
Choose the desired filter: 1-coffee filter or 2-coffee filter. The 2-coffee filter will require a
greater amount of coffee.
Follow the steps of the above section to fill the filter with coffee.
Note: Use freshly ground coffee to obtain best results.
Assemble the portafilter back in the appliance by rotating it to the right until it fits into the
lock position.
Warning: The device will switch to standby mode after 2 minutes of inactivity. If the device
enters standby mode, it is recommended to turn the On/off switch to the off position.
Brewing coffee
Note: Use only potable, fresh, cold water for brewing coffee.
Fill the filter with coffee (1-coffee or 2-coffee filter) following the instructions in the “Filling
the filter” section.
Install the portafilter following the instructions in the “Installing the portafilter” section.
Turn the device on by setting the On/off switch on. The red indicator light will start blinking
and the machine will start heating up.
Once it has finished heating, the red light will turn steady.
Slide the coffee switch downwards, the machine will start brewing coffee. One you have
obtained enough coffee, take the switch to the off position.
Brewing coffee with milk
Once your coffee has been brewed, start preparing milk:
Slide the steam switch downwards, the blue light indicator will start blinking.
Once the device has heated up, the blue light indicator will stop blinking.
Fill in a cup or mug with milk. It is recommended to use whole milk at room temperature
for better results.
Note:
Do not use warm milk with the steam function.
It is recommended to use a milk mug or container with a diameter not smaller than 70 ± 5
mm. Remember that the milk doubles its volume. For this reason, make sure the milk mug/
container height is sufficient.
Introduced the steam tube in the mug or container at a depth of 1-2 cm. When frothing
milk, move the mug or container up and down. Slowly rotate the steam knob anticlockwise
