Cecilware GB4M5.5, Руководство по эксплуатации, Страница: 19 / 43

yel
yel
yel
wht
CCW
WATER
PROPER
LEVEL
MAX
yel
Disconnect Existing
wire From RIGHT
DISPENSE VALVE &
Connect Here
CONNECT TO
LEVEL CONTROL
BOARD
CONNECT TO
TERMINAL BLOCK
NEUTRAL
HOT/COLD WATER VALVE CONVERSION KIT
19
INSTALLATION INSTRUCTIONS:
1. REMOVE EXISTING BOTTOM BACK PANEL.
2. INSTALL KIT/PANEL WITH THE 4 SCREWS SUPPLIED.
3. CONNECT HOSE (FROM TANK) WATER INLET, TO DUAL VALVE AS SHOWN.
4. CONNECT HOSE TO RIGHT DISPENSE VALVE.
5. CONNECT HOSE TO RIGHT MIXING CHAMBER SOCKET.
6. CONNECT TOGGLE SWITCH WIRES AS FOLLOWS: (see Wiring Diagram)
a. Disconnect Yellow wire from RIGHT Dispense Valve (coming from motors)
& Connect to CENTER Terminal of HOT/COLD Switch.
b. Connect Flag Terminal from HOT/COLD Switch to RIGHT Dispense Valve.
c. Check HOT & COLD operation to make sure that the HOT/COLD leads are not reversed.
OPERATION INSTRUCTIONS
:
BOTH HOT AND COLD WATER FLOW RATE IS FACTORY ADJUSTED, THE WATER
FLOW RATE MAY BE CHANGED IF THE USER DESIRES AS FOLLOWS:
A. SET HOT/COLD SWITCH TO COLD (bypass tank ass'y):
TO ADJUST THE COLD WATER FLOW USE THE FLOW ADJ. KEY.
1. CLOSE ADJUSTER WITH KEY.
2. OPEN ADJUSTER SLOWLY WITH KEY.
NOTE: WATER WILL SHOOT OUT OF VENT TUBE OF DISPENSE VALVE,
IF ADJUSTER IS NOT ADJUSTED AS DIRECTED.
3. ADJUST COLD WATER LEVEL IN THE
THE MIX. CHAMBER TO LEVEL SPECIFIED HERE,
WHICH WILL YIELD 33 gr/8 oz. OF CAPPUCCINO.
IF WATER LEVEL IS ABOVE THE MAX POINT,
IT WILL LEAK OUT.
B.
SET HOT/COLD SWITCH TO HOT
:
TO ADJUST THE HOT WATER FLOW
USE DISPENSE VALVE. SEE ILL. C.
HOT/COLD SWITCH
BEHIND HOPPER
L497A
SWITCH LABEL NB10A
Connect To RIGHT
DISPENSE VALVE
From Tank
(Incoming Water
Line)
FLOW
ADJUSTMENT
KEY
ADJUSTER (HEX HEAD PLUG)
HOSE BARB FITTING M576A
WASHER
FLOW CONTROL k415C
ELBOW
K555A
FLOW CONTROL ASS'Y
DUAL VALVE .75
gpm W/FLOW
WASHER TO
REGULATE BOTH
SIDES
Connect To
RIGHT MIX.
CHAM. SOCKET
M564A
Connect To
RIGHT Dispense
Valve
WATER INLET
CONNECTOR
W/ 1/4 FLARE
FITTING
Connect To
Water Inlet