Cecilware GB4M5.5, Руководство по эксплуатации, Страница: 12 / 43

LIT DISPLAY AND STARTER REPLACEMENT ILL. E
RECOMMENDED PREVENTIVE MAINTENANCE ILL. F
To replace the
fluorescent bulb:
Remove the upper inside door
panel. Turn the lamp and pull it
out of the lamp holder, then
place the new lamp into the
lamp holder and turn it until it
snaps into position.
To replace the starter:
Remove the upper inside door
panel, turn the starter slightly
counter-clockwise and take it
out of the starter base.
To install the new starter, snap
the starter into the starter base
and turn it slightly clockwise
into position.
1) CHECK ALL CHAMBER MOUNTS FOR SIGNS OF WEAR
A. Product Running Down The Front Of The Unit.
B. Product Built Up On The Back Of Chamber Mount.
Remove Chamber Mount.
Clean And Re-Lubricate Motor Shaft
Using Food Grade Lubricant Only
Replace With New Chamber Mount.
3) CLEAN OUT VENT MOTOR,
TROUGH AND TUBING.
Lift up black tabs, remove Trough Drawer,
Clean, and replace Trough Drawer.
Remove Hose Assembly From The Motor.
Clean Out And Replace.
2) CHECK ALL DISPENSE VALVES FOR LIME BUILD-UP.
Drain The Water Tank To Just Below The Level Of The Dispense Valves.
Remove The Valves And Clean. ( You Can Take These Valves Apart
By Hand As Shown).
Replace The Assembly As Needed (L467A).
Replace The Valve Into The Tank And Refill tank.
PRODUCT LABEL
BULB TYPE F8T5/CW
LAMP HOLDER
STARTER TYPE FS-5
STARTER BASE
DOOR FRAME
DISPENSE SWITCH
SWITCH PANEL LABEL
DOOR PANEL
PRODUCT LABEL
BREW SWITCH
STOP BUTTON [red]
SWITCH PANEL
LABEL
WINDOW LABEL
CORD SET
LAMP HOLDER
BULB TYPE
F8T5/CW
STARTER TYPE
FS-5
STARTER BASE
CORD SET
DOOR ASSEMBLY (GB3K SHOWN)
(ALL GBKs)
DOOR ASSEMBLY (GB3 SHOWN)
(ALL OTHER GBs)
WATER FLOW ADJUSTMENT