CEBORA S.p.A.
13
type of material (existing material and gas types may be selected using the (AM)
and (AX) buttons).
Correct?
♦
Each time the button (AH) is pressed, the leds Y-Z-AA-AB-AC-AD-AE-AF-AG
light in sequence, in observance of the conditions imposed by the selected
“Process” and “Mode”.
NO (see 3.5.3).
YES
3.4.2
- MIG mode.
WARNING
DURING THE FOLLOWING TESTS DO NOT AIM THE TORCH AT PEOPLE OR PARTS
OF THE BODY, BUT ONLY TOWARDS AN OPEN SPACE OR THE WORKPIECE.
Shut off the power source using the switch (BU).
Connect the gas supply to the fitting (BE) on the rear panel.
Connect the power cable provided to the connectors (BF) on the wire feeder and (BR) on the
power source.
Connect the MIG torch to the central adapter (BA) of the wire feeder (also connect the torch
commands patch connector to the connector (BB) on the wire feeder, if present).
On a water-cooled torch, connect the torch cooling lines to the fittings (BI).
On a water-cooled torch, remove the temporary by-pass for coolant circulation from the
fittings (BQ), and connect the hoses provided to the fittings (BT) on the cooling unit and (BH)
on the wire feeder, matching the hose color.
Connect the negative pole cable (BO) of the power source to the workpiece.
Restart the power source using the switch (BU).
After start-up, use the button (AI) to select the conventional MIG “process” (led R-3 on).
Use the button (AJ) to select two-stage “mode”, led (S) on.
Use the “diameter” and “material” buttons (AK, and AL) for which a program has already
been inserted, compatible with the torch used (e.g. : leds V-1,2 and W-FE lit).
Hold down the torch start button for a few seconds.
♦
Gas flows from the torch as long as the button is held down.
♦
The wire feeds from the torch, or the wire feeder motor begins operating, as long
as the button is held down (the wire speed is adjustable using the knob (N) and
displayed on the display (O) with led (C ) on).
Correct?
♦
The unit generates open-circuit output voltage as long as the button is held down,
shown on display (P) with led (J) lit.
NO (see 3.5.3, 3.5.4, 3.5.6,
3.5.7,
3.5.8).
YES
Move the torch near the workpiece and press the torch trigger.
♦
Begin welding. Turn the knobs (N) and (Q) to obtain the wire speed (shown on
display (O) with led (C ) lit) and output voltage (shown on display (P) with led (J)
lit) suitable for the welding to be performed.
♦
During welding, display (O) shows the welding current (with led (D) lit) and
display (P) indicates the arc voltage (with led (J) lit).
3.302.191
15/02/05
