10.1.2 Inserting
Step 1.
Check module compatibility (DC Voltage, Firmware version, AC Voltage).
Step 2.
Use a screwdriver and lightly rotate to release the latch of the handle.
Step 3.
Open the handle and Push firmly until the unit is properly connected.
Step 4.
Close the cover and latch in position.
A) Slide the module in
B) Push firmly till the connection is properly
engaged
C) Close the cover and latch the module in
place if too hard redo step B
Once the module is inserted correctly and locked, it will restart automatically and begin to share the load. The
sequence might take 10 to 40 seconds.
10.2 T2S ETH
T2S ETH is hot-swappable. It can be removed or replaced without affecting the operation of the system. If a new T2S
ETH is inserted in the live system, the modules will automatically configure the system parameters within the T2S ETH.
10.2.1 Removal
Step 1.
Use a small screwdriver to release the latch keeping the T2S in position.
Step 2.
Pull the T2S ETH out.
Release the latch
Insert screw driver
Figure 1.
T2S Removal
10.2.2 Inserting
Step 1.
Push the T2S firmly in place until the latch snaps in position.
Inserting/removing/replacing modules
30
- Bravo ST 120 Vac - 2+1 Redundancy - User Manual - v1.0
Содержание BRAVO ST-120 VAC-UL
Страница 38: ......
