3
cdvigroup.com
1
Measure and mark the center lines to determine the
reader position. Drill the fi xing screw holes (Diameter:
5mm). Drill the wiring access area (Diameter:
15mm).
2
Place the foam seal at the back of the reader. Take
care to begin from the bottom. (Sch. a). The foam
seal must be visible (about 2mm) on the top-back
of the reader (Sch. b).
4] MOUNTING
Make sure that there are no pieces missing from the mounting kit. Use the correct tools according to the
installation (drill, screwdrivers, tape measure,...) and follow the mounting instructions of the reader.
1
3
2
Sch. a
Sch. b
Sch. c
3
Insert the plastic plugs in the mounting holes, connect the cable (refer to wiring diagram on page 11), then fasten
the reader with the TORX
®
screw using the TORX
®
bit (Sch. c). Make sure that the varistor is connected across
the lock (refer to page 8 “Reminders and recommendations”).
Foam seal
EN
SOLARMWD - SOLARMBD
13.56Mhz EV1 Desfi re Mifare
®
Reader - Wiegand
INSTALLATION MANUAL
