Using your Hob
Please note:
•
A dot will show on either the zone control display or the timer display to demonstrate which is the active control. To
select a different control, touch either the required zone control key or the timer key.
To switch the zone on
•
Touch the zone control key for the required zone. The zone control display will flash with 0 and for the relevant zone
and the hob will beep to confirm the zone is on.
To set the power level
•
Touch the + key to increase the power level from 1 (lowest) to P (maximum) and the – key to reduce it.
•
To go straight to P, touch the – key once when the zone is switched on.
Please note:
•
If a power level is not set within five seconds, the zone will switch off automatically.
To switch the zone off
•
Touch and hold the zone control key for the required zone until the display switches off.
The timer
•
The timer allows you to preset the length of time any of the zones will be on, between a minimum of one minute and a
maximum of ninety-nine minutes. The timer can be used on each zone separately.
To set the timer
•
First switch on the zone and set the power level.
•
Touch the timer key repeatedly until the LED in the timer display is lit for the required zone.
•
Then touch the + and – keys until the timer display shows the required duration.
•
To go straight to the maximum 99 minutes, touch the – key once when the timer is switched on.
Please note:
•
The timer will only count down when the cookware is on the zone.
•
The timer will count down in minutes, and then in seconds for the last minute.
•
At the end of the set time, the zone will switch off, the timer display will flash 0 and the hob will beep for approximately
20 seconds. To stop the beep, touch any key.
To change the timer once set
•
Touch the timer key repeatedly until the LED is lit for the required zone.
•
Then touch the + and – keys until the display shows the required duration.
To cancel the timer once set
•
Touch the timer key repeatedly until the LED is lit for the required zone.
•
Then touch and hold the + and – keys simultaneously for approximately three seconds. This will cancel the timer.
Please note:
•
If you cancel the timer, the zone will continue at the set power level until it switched off as described above.