CDA FWV451, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 24

17
Installing the Wine Cooler
This appliance is intended to be
built into a tall larder type kitchen
cabinet. Due to ventilation
requirements it is not suitable for
installation below a worktop.
This appliance should be
installed in a well ventilated, dry
room.
This appliance must not be
installed:
- In direct sunlight.
- Adjacent to a heat source
such as an oven or radiator (with
the exception of the FWV600*).
- Below a hob unit.
Place your wine cooler in a location which is strong enough to
support its weight when fully loaded. To level the wine cooler, adjust
the levelling legs at the bottom of the wine cooler.
Ensure that there is an adequate flow of air at the rear of the cabinet,
as shown in the diagram.
Please note that a plinth vent of at least 200cm² is recommended
to allow for sufficient ventilation. If a ventilation intake is provided
elsewhere, the plinth vent may not be necessary.
Fig. 5
545
545
B
A
592
18
C
550 - 560
560 - 568
min. 200cm 2
min. 200cm
A
(Appliance
body height cm)
B
(Appliance door
height cm)
C
(Cutout height
cm)
FWV451 44.8 45.5 45 (min.)
FWV600 58.8 59.5 59 (min.)
FWV901 87.8 88.5 88 (min.)