18
fig. 7
fig. 8
fig. 9
Reversing the Door
You will need the help of another
person, during this process, to lean
the wine cooler back and support it.
1. Remove the rear ventilation trim
(3) by removing screws (1) from
both sides and sliding the trim out
from below. Then remove the front
ventilation trim (2) by removing
screws (4) from each side as shown
in fig. 7. These screws (4) are
located above and behind the front
ventilation trim (2) and their location
is indicated by the dotted line in fig.
7.
2. Remove the remaining plinth trim
supports (Fig. 10) by removing
the screws marked S1 through
the holes marked H1 and the
screws marked S2 through the
gaps marked as H2.
S1
H1
H1
S1
S2
S2
H2
H2
3. Remove the lower hinge (5) by removing the four screws (6) as
shown in fig. 8. Support the door as you do this to prevent damage.
fig. 10
