16
| Instruction Manual
Installation
Once you are content with the prepared area, drill out the holes
indicated by the markings on the template and insert wall plugs.
The three holes in the upper half of the supplied template are
where the mounting bracket is to be located. Fit this bracket now
(but do not mount the extractor yet).
Drill two holes indicated in
the lower half of the template
and insert wall plugs. Once
the extractor is mounted on
the bracket in Fig.5 , two extra
screws inserted here will provide
extra support for the extractor
body. There are pre drilled holes
at the back of the extractor
parallel to the motor for these
screws (Fig. 6)
When the steps above have been
completed, the extractor can be
placed on to the mounting bracket
as shown in Fig. 5. Once the
extractor is securely mounted on
the bracket, two screws should
be inserted through the small
brackets and in to the wall as
circled in Fig. 5. You should then
proceed to insert two screws
through the back of the extractor
to the wall via the pre- drilled
holes as shown in Fig. 6.
Hood Mounting
Bracket
Fig. 5
Fig. 6
