39
Connecting to the Mains Water Supply
1.
Check that the water supply pressure is in the range: 0.1-
1.0MPa. With higher pressures, use a pressure reducer.
2.
Connect the cold water supply hose (blue screw collar) to
the cold water tap with ¾” gas threaded connector, taking
care to tighten firmly to prevent leaks. The water supply
hose must not be kinked or crushed and must not be
changed or cut. Threaded connections must only be
tightened by hand.
Warning:
•
If the connection is made to new pipelines, or lines which
have been out of use for a long time, allow a considerable
amount of water to flow out before connecting the intake
hose. This prevents any grit or other dirt from fouling the
filters installed in the appliance to protect the water intake
valves.
•
The new intake hose supplied with the appliance must be
used, and the old water supply hose must not be used.
Drainage Connection
•
It is recommended that
you have a fixed
drainage outlet 60 to
70cm from the floor.
•
Avoid the drain hose
being too tight, kinked
or restricted.
•
The water outlet can
either be connected to
a water drain or to a sink outlet spigot. This connection
should be a minimum of 60cm and a maximum of 100cm
from the floor.
•
The drain hose should be no longer than 4m in length to
ensure good performance from the washer dryer.
Содержание ci971
Страница 1: ...ci971 Washer Dryer 7 4kg 1400 Spin Manual for Installation Use and Maintenance ...
Страница 42: ...42 International Washing Signs ...
Страница 43: ...43 NOTES ...
Страница 44: ...44 1 brackets ...