CDA ci971, Руководство по установке, использованию и обслуживанию

Страница: 18 / 44

18
3 To change the washing programme, simply turn the
“Programme Selector” knob to select the new
programme; there is no need to set the appliance in
pause status. The new cycle will be carried out
completely, beginning from the start. If the tank had
already been filled with water during the previous cycle,
the water intake phase will be omitted from the new
programme.
4 To restart the cycle, press the “Start/Pause” button
again.
The End of the Programme
Washing / drying programmes are completed automatically. The
word END appears on the display and the "Time Remaining" light
goes out.
1 Switch the appliance off by turning the “Programme
Selector” knob to “OFF “
2 Unload the laundry from the drum.
3 Leave the door ajar to allow the interior of the washer
dryer to dry out.
4 Turn off the water intake tap.
If during the initial spin speed setting stage the "no spin" mode
was selected, at the end of the washing programme the word
“STOP” appears on the display, alternating with “----“, the “Spin”
light stays on.
To proceed with the pump-out and spin, press the spin selection
button twice. The appliance restarts the cycle with the pump-out
and spin. To select the spin speed required, press the button until
the chosen speed is displayed. To pump out the water from the
tank without performing the spin, press the spin selection button
until the display indicates speed of “0”: the pump-out will be run
without spin.