Need a little extra help? email:
HD Mule Instructions
3
On installations where you have only one co-ax cable installed, the HD Mule makes it
really easy to add extra cameras - it saves time, saves money & saves mess.
Perfect if you don’t have access to run any more cables, even data cables, underground.
The clever electronics of the MULE102 allow it to carry the RS485 data along the same RG59
Co-ax cable enabling the operator to monitor and control the system from a diff erent location.
Using multi-signal technology the HDMule works with TVI, CVI, AHD and even analogue
cameras for maximum fl exibility.
Please Note -
some HD cameras (TVI, CVI and AHD) use “up the co-ax” menu control, because
of how the HDMules work this “Co-axitron” will not work through the Mule, however on PTZ
and similar cameras you can use the Mule’s RS485 transmission to operate the camera.
Higher resolutions than the stated ones may work on shorter cable lengths but with so
many variables involved like camera technology, distance, cable quality and frame rate, the
maximum resolutions are stated for guidance. On most HD cameras you can adjust the output
to suit and we suggest setting this to 2MP.
Carries multiple HD video signals - even data
- down
ONE
RG59 cable!
Connections - Transmitter (Tx)
Connections - Receiver (Rx)
P
1 IN
2 IN
VID/DATA VID
DC 12V
VIDEO OUT
BNC video input from camera
Power LED shows
power is connected
BNC video input or RS485 data output
depending on operation mode
BNC video out to Rx
2.1mm 12V DC socket
VIDEO IN
1 OUT
2 OUT
P
VID/DATA VID
DC 12V
BNC video in from Tx
Power LED shows
power is connected
BNC video output or RS485 data input
depending on operation mode
BNC video output to DVR
2.1mm 12V DC socket
