49
In
{New}
, At least, one storage shall be selected as a dedicated storage. Otherwise, the data
cannot be stored in the real time.
①
iSCSI
iSCSI HDD Setting. (Please refer to ‘6-6-6’ for more details)
(2) Composition of the local storage device
※
There are three software status types.
Active
Connected to storage or backup device; currently saving the data.
Online
Only connected to storage or backup device.
Offline
Not connected to storage or backup device.
※
There are three hardware status types.
Healthy
Connected to storage or backup device; functions normally.
Warning
Connected to storage or backup device, but error was detected; in this case, data
storing or backup cannot be made (for more information, see the description below).
Fault
Not connected to storage or backup device; cannot perform data saving or backup.
1.
Fault State
: The storage device is completely damaged, and none of the S/W operations
can be performed. The fault state is not related to a DVR problem. The DVR has detected the
fault and stopped the recording.
2.
Warning State
: The storage device has a physical error that can be corrected by the storage
device or by the DVR. If the error is not taken care of, however, the storage device is likely to
be damaged (and shift to fault state). Backing up data in the corresponding storage device
and replacing the device with a normal one are strongly recommended.
3. If there is an active storage device with a warning or a fault, a message is displayed on the
upper left part of the screen.
(3) Instruction when adding the local storage device
①
Open the system body and install a new disk (connect the data cable and the power cable)
②
Connect power to the system and boot the system.
③
Select
{Menu}
{Setup}
{Storage}
by using the arrow keys and the Select button.
④
A newly displayed disk will then be displayed as
{New}
.
⑤
Select a newly installed disk by using the arrow keys and the Select button and initialize the disk
as a {Recording} or a {Backup} disk. The following describes the method of setting the recording st
orage.
⑥
{Recording}
shows the status of the newly installed disk online.
※
Selecting {Recording-Format} or {Backup-Format} causes all data in the device to
be erased. Therefore, caution is required.
※
While {Recording-Format} or {Backup-Format} is being set up, do not remove the
device (may cause an error when detecting the device).
※
To use the external or portable storage device for system upgrade, set to {Backup-
Init} in the {New} item for {Main Setup} {Storage Device} {Local Storage Device
Management}.
※
When used in DVR equipment for the first time, a backup USB device will always be
detected in the {New} category. Therefore, a USB device in the {New} category must be
set up as {Backup-Format} prior to use for backup. A USB device that has gone
through this procedure will be detected in the {Backup} category when used again in
the DVR equipment.
Содержание Cobra Elite 960H
Страница 1: ...960H Ver 2 0 Elite ...
