16
AUTO DIMMER
- Slide to the
[
AUTO ]
position, and the brightness of backlight will automatically adjust based on the ambient
room lighting (dims in low light).
- Slide to the
[
LO ]
position for the dimmer backlight.
- Slide to the
[
HI ]
position for the brighter backlight.
MAINTENANCE
TO CLEAN THE RAIN COLLECTOR
1. Rotate the rain collector by 30° anticlockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or insects.
4. Install all the parts when they are fully clean and dried.
N
N
“Unlock” Position
“Lock” Position
N
N
TO CLEAN THE THERMO/HYGRO SENSOR
1. Unscrew the 2 screws at the bottom of the radiation shield.
2. Gently pull out the shield.
3. Remove carefully any dirt or insects inside the sensor casing (Do not let the sensors inside get wet).
4. Clean the shield with water and remove any dirt or insects.
5. Install all the parts back when they are fully clean and dried.
TROUBLESHOOTING
Problem / Symptom
Solution
Strange or no measurement of Rain Sensor
1. Check the drain hole in the rain collector.
2. Check the balance indicator
.
Strange or no measurement of Thermo / Hygro
Sensor
1. Check the radiation shield.
2. Check the sensor casing
.
Strange or no measurement of Wind Speed and
Direction
1. Check wind cups (Anemometer).
2. Check the wind vane.
and
(Signal lost for 15 minutes)
1. Relocate the main unit and 5-in-1 sensor
closer to each other.
2. Make sure the main unit is placed away from
other electronic appliances that may interfere
with the wireless communication (TVs,
computers, microwaves).
3. If problem continues, reset both main unit and
5-in-1 sensor.
and
(Signal lost for 1 hour)
PRECAUTIONS
• Read and keep these instructions.
• Heed all warnings and follow all instructions.
• Do not subject the unit to excessive force, shock, dust, temperature or humidity.
• Do not cover the ventilation holes with any items such as newspapers, curtains etc.
• Do not immerse the unit in water. If you spill liquid over it, dry it immediately with a soft, lint-free cloth.
• Do not clean the unit with abrasive or corrosive materials.
• Do not tamper with the unit’s internal components. This invalidates the warranty.
• Only use attachments/accessories specified by the manufacturer.
• Images shown in this manual may differ from the actual display.
• Placement of this product on certain types of wood may result in damage to its finishing for which
manufacture will not be responsible. Consult the furniture manufacturer’s care instructions for information.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• Only use fresh batteries. Do not mix new and old batteries.
