Speed Dome Camera Instruction Manual
17
Check Points before Operation
z
Before power is applied, please check the cables carefully.
The camera ID of the controller must be identical to that of the target camera. The camera ID can be checked by
f the camera.
z
If yo r controller supports multi-protocols, the protocol must be changed to match to that of the camera.
z
If you changed camera protocol by changing DIP switch, the change will be effective after you reboot the
amera.
z
Since the operation method can be different for each controller available, refer to the manual for your controller
if camera can not be controlled properly. The operation of this manual is based on the standard Pelco®
Controller.
z
reading DIP switch o
u
c
Preset and Pattern Function Pre-Check
z
Check controller or DVR preset and pattern functions in advance when using controller or DVR.
z
Refe
following table when using standard Pelco® protocol controller.
r to the
< Go Preset >
Input [Preset Number] and press [Preset] button.
< Set Preset >
Input [Preset Number] and press [Preset] button for more than 2 seconds.
< Run Pattern >
Input [Pattern Number] and press [Pattern] button.
< Set Pattern >
Input [Pattern Number] and press [Pattern] button for more than 2 seconds.
z
If c
info
ontroller or DVR has no pattern button or function, use shortcut keys with preset numbers. For more
rmation, refer to “Reserved Preset
”
in this manual.
OPERATION
3
