CBC Ganz ZT-WD Series, Инструкция по эксплуатации

Страница: 14 / 27

14
OSD Menu
C. White Balance Setting
ATW
SPEED 250
DELAY CNT 005
ATW FRAME X2.00
ENVIRONMENT OUTDOOR
RETURN
↵
C-1. ATW (Auto Tracking White balance)
The color temperature range for the proper white balance is approximately 1,800°K to 10,500°K. Proper
white balance may not be obtained under the following conditions:
- The color temperature is out of the 1,800°K to 10,500°K range
- The scene contains mostly high color temperature objects, such as a blue sky or sunset.
- When the image is dim.
C-1-1. SPEED : Use [LEFT] or [RIGHT] to set the ATW pull-in speed. If selecting high level, ATW pull-in speed
becomes higher. (000 ~ 255)
C-1-2. DELAY CNT : You can adjust the time based hysteresis of ATW. (000 ~ 255)
C-1-3. ATW FRAME : You can set the AFW frame level. If you set frame level high, the track will be faster. (X0.50,
X1.00, X1.50, X2.00)
C-1-4. ENVIROMENT : Use [LEFT] or [RIGHT] button to select a function.
- OUTDOOR : to set on the assumption that outdoor light sources (mainly sunlight) will be used for
shooting.
- INDOOR : to set on the assumption that indoor light sources (mainly sodium vapor lamps and indoor
lights) will be used for shooting.
C-2. PUSH : If setting the PUSH mode, you will be able to setup the White Balance automatically using [SET]
button.
C-3. USER1 : You can set the white balance options.
- B-GAIN: Obtains the optimum amount of blue gain.
- R-GAIN: obtains the optimum amount of red gain.
C-4. MANUAL : You can set the white balance options manually. The actual variable range is limited to
the range from the low color temperature (approximately 1,800°K) to the high color temperature
(approximately 10,500°K) stored when the pre-white balance was adjusted.
C-5. ANTI CR : This function minimizes the color changes (color rolling) over long periods caused by very small
differences between the flicker frequency of non-inverter fluorescent lights and the drive frequency of
the image sensor devices.
C-6. PUSH LOCK : If selecting the PUSH LOCK mode, you prevent to setup the White Balance automatically by
using [SET] button.
Select the method by which the camera shifts its output colors to compensate for the color of a light source.
The default level of “Speed” is enough and the best for user to use, when “SPEED” is
highest, “DELAY CNT” and “ATW FRAME” will be able to neglect.
Note!!