CB Tech WATER GUARDIAN MPADC, Руководство пользователя

Страница: 7 / 24

5
Installation
Inspect Your Drinking Water System
1. Inspect your DWS to confirm that it has been received in good condition
and that all parts are included.
2. Determine a countertop location for system placement, factoring in
distance to the faucet for diverter valve and hose connection.
3. Inspect the system housing to confirm that the housing top and bottom
are securely connected.
a. With the system sitting upright, slide the hand tool over the top so
that the ridges on the tool fit into the grooves on the housing top.
b. While holding the system base in place, firmly turn the hand tool
clockwise to tighten the housing top.
Connect The Hose To The Housing
1. On the diverter valve and hose, locate the
two stems at the end of the hose opposite the
diverter valve. Identify the large stem (Inlet
Stem) and small stem (Outlet Stem).
2. On the DWS, locate the two ports on the bottom rear of the system housing.
Identify the lower, large port (Inlet Port) and upper, small port (Outlet Port).
3. Insert the Inlet Stem into the Inlet Port by slowly pushing the stem straight
into the port as far as possible. Confirm the connection by pushing the
stem in again.
4. Insert the Outlet Stem into the Outlet Port by slowly pushing the stem
straight into the port as far as possible. Confirm the connection by
pushing the stem in again.
Connect The Hose And Diverter Valve To The Faucet
1. Remove the aerator or screen (if present) from the end of the faucet. If
facing the open end of the spout, rotate the aerator counter-clockwise
to loosen and remove.