INSTALLATION GUIDE
16
Rev. 0/ 14-07-2020
MECHANICAL INSTALLATION
Warning: This product, as of the date of its manufacture, is designed and tested to conform to all
governmental or industry safety standards then existing as they may apply to the manufacturer. The
purchaser and user of this product are warned that compliance with all country, state, and local
codes required in order to avoid the hazards of leaking gas resulting from improper installation, start-
up, or use of this product, and further, that all fire control, building codes, or other safety regulations
established under public laws which regulate or govern the application, installation, operation, or
general use of this product, should be complied with. In order to ensure the safe and proper
operation of this product, the manufacturer recommends that a qualified technician following NFPA
54 standards to install this product such as:
-
Where they are not subjected to damage, such as adjacent to a driveway, under a fire escape,
in public passages, in coal bins, or where they will be subject to excessive corrosion or
vibration.
-
Where they are not subjected to extreme temperatures, sudden extreme temperature
changes, or temperatures beyond those recommended by the manufacturer.
-
In ventilated spaces readily accessible for examination, reading, replacement, or
maintenance.
WARNING: For proper use and safe operation, pay close attention to and follow the following
instructions when installing the device:
-
The PRODIGI device must be connected to the system. Before connecting, make sure that at
least the section of the system upstream of the meter has been intercepted and therefore
there is no gas supply during the installation phase;
-
Before connection, make sure that the maximum pressure of the system is lower than the
maximum pressure foreseen by the meter, which is fixed and equal to 7.2 psi;
-
If necessary, use fittings to connect PRODUCTS to the pipeline (not supplied).
-
When tightening the fittings, do not exceed a torque of 110Nm;
-
PRODIGI only operates in a vertical position;
-
PRODIGI is supplied with the shut-off valve in the "open" state for which it is ready to
dispense and measure the gas.
-
Check that the customer's utilities are closed.
-
Slowly load the PRODUCT with the pressure.
-
After checking the tightness, slowly remove pressure from the PRODIGI meter.
Once the leak test has been successfully completed, the meter is ready for use.
Comentado [GA10]:
7.2 psi or 5 psi? To be defined with
UL
