Cattron MKU OCU, Руководство пользователя

Страница: 23 / 41

23
MKU OCU
User Manual
8.2 If the Stop switch verification at Startup is disabled
1. The
‘STATUS’ LED will illuminate flashing GREEN at an approximate rate of 2 cycles per second. The OCU
is ready for use and a power up message has been sent to the target MCU. The targeted MCU will respond
by energizing the mainline contactor of your controlled machine.
WARNING
Before attempting to use the remote control system, verify the target crane or machine you wish to
operate is under the direct command of your OCU. This is accomplished by operating a non-
motion OCU function such as a horn or lamp and observing that the respective function on the
targeted crane or machine responds.
Failure to implement the above may result in serious injury or death to personnel and damage to
equipment.
2. Press a non-motion function key (pushbutton) such as a horn or lamp and observe that the targeted crane or
machine responds. The OCU is now fully operational and transmitting a signal as indicated by the flashing
green ‘TRANSMIT’ LED. Operate the keypad control and auxiliary pushbuttons as required, remembering that
each pushbutton must be maintained in order for the function to continue to operate. Any or all functions may
be operated simultaneously if the controlled machine permits such operation.
Note: A system STOP may be initiated at any time during the control function by pushing the red STOP
switch downwards. When all control functions have been completed, we recommend you initiate a
system STOP (push red STOP switch down) before setting the ON/OFF s
witch to the ‘OFF’ position.
Note: Pushing the red STOP switch downwards does NOT switch off power to the OCU. To prevent the OCU
from consuming power, the ON/OFF switch must be set to the ‘OFF’ position.