-22-
7. Install the tank cover
(see Figure).
8. Assemble reflector with small wing nuts and
bolts as shown in Figure.
9. Install reflector over post on top of burner
assembly. Install reflector cap over post.
Attach reflector and reflector cap using large
wing nuts (see Figure).
10. Inspect length of gas hose on bottom of
burner assembly for any cracks, cut, holes
hose is damaged.
11. Sliding hose into upper pole, install burner
and reflector assembly to base (see Figure).
12. Align hole in burner
assembly pole with hole in
upper pole. Secure burner
assembly to upper pole
using a wing bolt. Be sure
to tighten wing nut completely.
13. Install regulator hose to burner.
14. Securely connect regulator to LPG cylin-
der. When connecting regulator assembly to
tank valve, hand tighten nut clockwise to a
positive stop. DO NOT use a wrench to tigh-
ten. Use of a wrench may damage quick clo-
sing coupling nut and result in a hazardous
condition.
15. Open cylinder valve. Apply a noncorrosive
leak detection fluid to connections at regulator.
Bubbles forming show a leak.
16. If leaks exist, turn off LPG cylinder valve.
Disconnect leaking connection. Check and
clean connection. Reconnect regulator and
leak check again.
17. If no leaks are present, pull cover down
over tank and legs. Unit is now ready to light.
E
