Caton Vpro 5100, Руководство пользователя

Страница: 14 / 26

VprO 5100/5100D User's Guide
- 14 -
2-3-2 ASI menu parameter display
ASI menu requires no parameter setting and it works automatically. if valid signal
is detected, it will show SYNC ON.
2-3-3 IP menu parameter setting and display
Name Setting range Explanation
Port Num 0-65535 Set ip in port num
IP Type Multicast Set multicast receive mode
Unicast Set unicast receive mode
PKT Type RTP Receive RTP packet
UDP Receive Raw UDP packet
Multicast Addr XXX.XXX.XXX.XXX Set multicast address
SSM Enable Open SSM
Disable Close SSM
Source Addr XXX.XXX.XXX.XXX Set Source Address
When the RF signal is from a QPSK/8PSK modulator, you need to
check two things
One: if LnbLow=0 then Freq=DownFreq
Two: if LnbLo=!0 then
Under C band :Freq=LNBLow-DownFreq, LNBLow can be set 5150
Under KU band:Freq=DownFreq,LNBLow can be set 10000
Multicast setting will be active only if IP Type is set to Multicast. If IP
Type is set to Unicast, it uses the IP address which can be configured in
network menu.
When all of the parameter settings are correct the IP menu shows
SYNC ON. If you want to use IP as the source of decoding, don’t forget to
select it in workmode menu.