23
CARE AND CLEANING
Wash the water tank in warm water using
a soft sponge, then wipe dry with a dry
cloth. Before replacing, make sure the tank is
completely dry.
Cleaning brew head, handle and strainers
It’s important to clean the handle and the
strainers under running water after every
use. Then wipe dry.
Wipe the inside of the brew head with
a clean cloth slightly moistened in warm
water.
If the strainer meshes are blocked, free them
with a fine brush.
Cleaning the brew head sealing
The sealing is located at the sealing head
bottom. It has the sealing function during
the coffee dispensing after the handle has
been inserted in the brew head.
NOTE
When the appliance is to be left
unused for a prolonged period of
time, it's important that the handle
should never be inserted in the brew
head. This would shorten the sealing
lifetime.
The sealing must be replaced on regular
basis. The average sealing lifetime is about
12 months depending on the frequency of
use. The sealing must be replaced when it
starts malfunctioning with the steam leaking
from the brew head during the coffee
dispensing. In such case, please contact
Catler authorized service centre.
Cleaning the hot water discharge spout
Wipe hot water discharge spout with a clean
cloth slightly moistened in warm water.
Cleaning the outer surface
Wipe the outside surface and the cup
heating area with a soft, slightly moistened
sponge. Wipe with a soft and dry cloth.
WARNING!
Do not use abrasive
cleaning agents,
steel wools, wire
sponges etc.,
as these might
damage the surface.
CLEANING THE STEAM JET
Clean the steam jet after each use. Dry milk
residues may block the steam jet, affect the
milk texturing as well as degrade the milk.
Wipe the steam jet with a clean, slightly
moistened sponge after each use. Start the
steam function with the steam dispenser
control. Have the steam escape from the
jet for several seconds, then set the steam
dispensing control to the OFF position. Wipe
the steam jet again with a clean, lightly
moistened sponge.
If the steam jet gets blocked with dry milk,
wrap the steam jet end in a clean and soft
sponge slightly moistened in warm water
and have the steam function run for about
10 seconds. Have the steam act for about
5 minutes, then remove the sponge and wipe
off dry milk residues.
Repeat the procedure if needed.
If the steam jet gets blocked and the above
procedure is inefficient, free the holes in the
brew head using the cleaning aid needle.
This is located inside the appliance behind