Cathode Corner NWRF Nixie, Руководство пользователя

Страница: 9 / 16

9
Operating Instructions
Installing the Battery
The watch is shipped with a fresh CR2 lithium battery. To install the
battery, you must open the watch case. This is done by holding the
back of the case by the strap lugs in one hand while turning the front
cover counter-clockwise with the other hand.
The battery fits into the open space with the spring holder. The spring
is in contact with the negative (-) terminal of the battery, while the
positive (+) terminal rests against the flat round contact. To insert the
battery, push its negative end against the spring terminal until the
positive end slips into position. Be careful not to disturb the black
adjustment capacitor to the left of the lower end of the battery. The
spring is rather strong to keep the battery from losing contact when
the watch is bumped.
Setting the time
You may set the time on the nixie watch by pushing the two buttons
below the display in the proper sequence. The button on the left side
is the Set button. It selects the time-setting mode. The button on the
right is the Adv button. It advances that portion of the time that is
selected for setting. If you push the Adv button first, the watch will
enter the diagnostic tilt display mode.
The Set button cycles through a sequence as follows:
Normal display mode
12/24 hour select
Hour setting
Tens of minutes setting
Units of minutes setting
Seconds reset