6.
Odometer Input
– to enter previous odometer miles press the silver
MENU
button,
press the
M1/+
until you get to the ODO INPUT screen. Press
SSE
to start entering
an odometer number starting with the far right number first. Use the
M1/+
and
M2/-
to
toggle though each number, press
SSE
to move over to the next digit to the left.
When complete press silver
MENU
button on back of computer
NOTE:
ride data must be 00 to make changes to measurement unit. To do this you must return to
the mail
MENU
then simultaneously press the
SSE & M2/-
buttons for several seconds then release
7.
Unit -
to change unit of measure from mph to kmh press the silver
MENU
button on
the back of the computer, then press
SSE
, use the
M1/+
to toggle between mile and
km, to confirm press the silver
MENU
button on the back
8.
Sensor-ID
– to check or change sensor ID press the silver
MENU
button on the back
of the computer, press the
M1/+
until you get to the SENSOR-ID screen, then press
the
SSE
button to view the sensor number. To change or re-sync sensor press
SSE
then spin your rear wheel until the “ID-OK” screen appears
9.
Wheel
: to change tire size press the silver
MENU
button on the back, then
M1/+
until
you get to the WHEEL screen. You may set two tire sizes. The “A” tire size will be
visible first. Press
SSE
to get the “A” to flash. To set up the “B” tire size for use on a
second bike press the
M1 /+
so that Wheel: “B” is showing. (If you do not want to
program an additional tire size just press the
SSE
button while the “A” flashes) Now
use the
M1/+
and
M2/-
to program the last two digits, then press the
SSE
to get the
first two digits to flash, use the
M1/+
and
M2/-
to set the first two digits. When
complete press the
SSE
button. From here you can program the “B” tire size by
pressing the
M1/+
button while the “A” is flashing. After toggling to the “B” you will
press
SSE
and follow the process above. Once complete press the silver
MENU
button
