11
MOUNTING AND PAIRING THE REMOTE CONTROL SWITCH
How to mount
How to pair
Follow the steps below to pair the remote control switch with a light unit.
* The included remote control switch has been paired with the light unit at the
factory, so pairing is not necessary before use.
CAUTION!:
• Do not look directly at the light when it is on.
• Perform pairing within 1 m from each other.
1. Press and hold the switch on the light unit for 4 seconds. The switch will flash
and await a signal (pairing mode) for 5 minutes.
* Keep pressing the switch even when the light turns on.
* To exit the pairing mode, press the switch on the light unit.
2. Pressing the remote control switch while the light unit is in pairing mode will
flash the light three times and complete the pairing. Press the remote control
switch to check that the light turns on.
Press and hold
(4 seconds)
Flashing
Pairing mode
(5 minutes)
Flashing light
Pairing complete
Click
Insulation
sheet
Rubber band
(WSW-001)
