23
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container th at is held outside and lower than the sink.
Water Outlet
The following things should be checked before starting the dishwasher.
Syphon Connection
After installation, please keep this manual for future reference.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is no water leaking from any of the hose connections
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are secure
7
All packing materials and
the dishwasher
have been removed from the inside of
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to mak e sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet becom ing blocked and damaging the appliance.
The water supply to the appliance can also be connected to the household hot water
line (s uch as, central s ystem, hea ting system),as long as it does not exceed a
tempe rature of 60 C. In this case, the wash c ycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connec tion must be made to the hot water line following the same procedures as
described in the section for the connec tion to the cold water line.
Position the appliance in the d esired location. The back sh ould rest against the wall behind it, and the sides,
along the ad jacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip. The free end of
the hose must not be immersed in water.
For models not fitted with a safety inlet hose, in order to prevent continual water pres sure in the inlet hose, please turn
off the water supply after each use.
