EN
9
Cool light: ( ) Default setting for all lights.
Warm light: ( ) Optional setting for all lights.
To change these settings press ( ) or ( ) and press the Light (
) icon to accept
the change.
GENERAL USE
ON/OFF AND INCREASE/DECREASE THE FAN SPEED
Press the decrease fan speed ( ) icon and the fan will turn on at speed 1.
Press the increase fan speed icon ( ) and the fan will turn on at maximum speed
(Booster)
If the fan motor is set at speeds 2,3,4, 5 or P, pressing the Fan Decrease ( ) Icon will
reduce the speed by one level at a time. If you press the Fan Decrease ( ) Icon for
more than three seconds, the fan will turn down. However, the downlight will remain
on 8 if enabled).
If the fan motor is set at speed 1, pressing the Fan Decrease ( ) Icon the motor will
switch off. However, the downlight will remain on (if enabled) and the display will show
the current brightness level.
Boost Function
If the fan motor is set at speeds 1,2,3,4 or 5, pressing the Fan Increase ( ) Icon will
increase the speed by one at a time. If you press the Fan Increase ( ) Icon for more
than two seconds, the speed will increase to full power from any level and the display
will flash “P”
NOTA:
Full power or Boost (P) only operates for five minutes maximum to conserve
energy and the fan speed will automatically drop to speed level 5 after this time.
Light On/Off ( )
Touch the Light (
) Icon to turn on the downlight.
To change the brightness of the downlight, touch and hold the Light (
) Icon until the
display show the brightness sequence. Remove your finger from the Light (
) Icon
when the desired brightness is achieved. The sequence runs from L1 to L5 and back to
L1 in steps. The selected brightness will flash for a few seconds and revert to the fan
speed display. This lighting setting will be kept for future uses.
Setting the timer (
)
• When the fan motor is on and the Timer ( ), icon is pressed the icon will turn
