9
Loctite and 242 are registered trademarks of the Henkle Corporation
2.47 Hand thread ceramic plunger assembly
onto each plunger rod.
2.48 Use a M30 hex wrench to tighten the
plunger retainers. Torque to 588 in/lbs,
49 ft/lbs or 66 Nm.
2.49 Slide seal retainer assembly over each
plunger rod. Position wick downward.
REASSEMBLY OF PLUNGERS
NOTE: Lubricate o-rings and backup-rings on plunger retainers prior to reassembly.
2.44 Slide barrier slinger over plunger rod
and position against step on
plunger rod.
2.45 Slide keyhole washer over plunger rod
and position against barrier slinger.
2.46 Place a drop of Loctite®242®on the end
of each plunger rod.
2.40 Install gasket onto each plunger
retainer.
2.41 Position o-ring into groove of each
plunger retainer.
2.42 Position backup-ring into groove on
top of o-ring of each plunger retainer.
2.43 Insert plunger retainer assembly into
ceramic plunger.
Содержание 67102
Страница 15: ...15 ...