background image

 

CBW383G1IND    Cable Modem Quick Installation Guide

 

Federal Communication Commission Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection against harmful 
interference in a residential installation.    This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications.    However, there is no guarantee that interference will not occur in a particular 
installation.    If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one 
of the following measures: 

 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 
 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

 

FCC Caution:

 

Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user's authority to operate this equipment.

 

 

IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To 
maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction 
as documented in this manual. 

 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

This device is intended only for OEM integrators under the following conditions: 
1)  The antenna must be installed such that 20 cm is maintained between the antenna. 
2)  The transmitter module may not be co-located with any other transmitter or antenna. 
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator 
is still responsible for testing their end-product for any additional compliance requirements required with this 
module installed (for example, digital device emissions, PC peripheral requirements, etc.). 

 

 

Содержание CBW383G1IND









Отзывы: