Castelle FAXPRESS PREMIER, Руководство администратора

Страница: 586 / 639

Admin Guide > Analog Hardware Upgrade
570
17. Replace the 2 rear panel screws that hold the bottom portion of the power supply
to the rear panel of the FaxPress Premier, and then replace the 2 nuts with lock
washers that hold the power supply to the base of the chassis.
18. Slide the FaxPress Premier cover back into place, making sure the leading edge
fits under the front panel lip.
19. Replace the cover screws, keeping in mind that there are 5 for the back panel, 3
along the bottom of each side, and 3 holding the leading edge under the front pan-
el lip. Tighten the fourth front panel lip screw if you loosened it.
The upgraded FaxPress Premier Analog board is now ready to be connected and configured
for service. See the next section, Configuring the Dialogic System Software on page 570
for configuration information.
Configuring the Dialogic System Software
After adding the analog fax boards as described in Adding Fax Boards on page 562, and
after connecting all necessary cables to the unit, follow these steps to configure the Fax-
Press Premier:
1. Access the FaxPress Premier server by connecting a keyboard, mouse and monitor
to it.
Note: This task cannot be performed remotely. The unit must be accessed
using a keyboard, mouse and monitor.
2. Power up the FaxPress Premier. A message may appear briefly, telling you that the
new board has been detected. This will only occur the first time you upgrade.
Note: For Windows 2003, please wait approximately 1 minute before
continuing. This ensures that all fax boards are fully detected.
3. In the Found New Hardware Wizard dialog box, select No, not at this time.
Press Next>.
4. In the next Found New Hardware Wizard dialog box screen, select Install the
software automatically (Recommended). Press Next>.
5. In the Security Alert - Drive Installation dialog box, press Yes.
6. The Completing the Found New Hardware Wizard dialog box appears. Press
Finish.